Home » DataWarrior » Functionality » unable to create new filters (in dwar files I cannot add or create new filters because "uncaught exception:-1" )
unable to create new filters [message #2008] Tue, 12 September 2023 19:02 Go to previous message
juliocoll is currently offline  juliocoll
Messages: 27
Registered: January 2023
Location: Madrid SPAIN
Junior Member
I am adding one "ADV, nM" column to 9 dwar files provided with several [slider] filters.

- Five of 9 files allowed me to include the new filters without problems, but an "uncaught exception:-1" stops now any further filter addition (example LolCE100C8.dwar).

- Three of the 9 refuse the new slider (example workc1100C1.dwar).

- One of the 9 shows the filter list after adding the 4 filters and allows to create new filters (example sglt1-100C13.dwar)

I tried to rebuild the dwar files from initial data, change the column alias, eliminated empty rows and/or changed in every possible way the existing filters (enable, disable, reset,remove) but cannot progress beyond the Edit/New Filter/Uncaught Exception:-1.....

Any ideas to understand and/or solutions to try this issue?
Thanks for your attention

Julio Coll
Profesor de Investigación. Emérito
CSIC-centro Nacional INIA, Madrid, SPAIN
Dr. Biologia Univ.Comp(UCM). Madrid, Spain
PHD. Biology Mass.Inst,Technol (MIT). Massachusetts, USA
orcid: 0000-0001-8496-3493
Read Message
Read Message
Read Message
Read Message
Previous Topic: Splitting reactants column
Next Topic: extension of substructure definition
Goto Forum:

Current Time: Sat May 25 12:39:50 CEST 2024

Total time taken to generate the page: 0.03961 seconds