Problem with importing macros from previous versions [message #186] |
Thu, 18 August 2016 19:12 ![Go to next message Go to next message](/forum/theme/myThemeWithHFCSS/images/down.png) |
estangeland
Messages: 1 Registered: August 2016 Location: United States
|
Junior Member |
|
|
First of all, Datawarrior is an incredible piece of software that I use on a daily basis, so thank you very much for sharing the program.
Today I updated my DW from 4.2.2 to 4.4.1. Prior to the update, I copied all of my macros to a separate folder to avoid them getting lost. After I updated the program, I copied each macro back the the macro folder in DW. However, several of my macros no longer work. As far as I can tell, my macros that were created prior to 4.2.2 are the problem. All of the macros worked in 4.2.2.
I plan to look at all the files in texteditor to see if I can figure out what the problems were, but since I assume others will also experience this problem, I thought I'd post my question.
Thanks
|
|
|
|
Re: Problem with importing macros from previous versions [message #190 is a reply to message #187] |
Sun, 21 August 2016 00:54 ![Go to previous message Go to previous message](/forum/theme/myThemeWithHFCSS/images/up.png) |
thomas
Messages: 693 Registered: June 2014
|
Senior Member |
|
|
Thank you for sending me some test macros. Sadly, I found that the 'Add Row Numbers' task contained
a bug that caused a null-pointer-exception if no category column was used. I considered this serious
enough to immediately release a bugfix, which I just have done (v4.4.2).
Thank you for helping fixing this issue by telling me and sending the macros.
Kind regards,
Thomas
|
|
|