Choosing X-Y Axes in 2D Views [message #1340] |
Wed, 14 July 2021 21:08 ![Go to next message Go to next message](/forum/theme/myThemeWithHFCSS/images/down.png) |
ELFritzen
Messages: 47 Registered: November 2019 Location: North Carolina, US
|
Member |
|
|
I recently noticed while attempting to choose an x or y axis in a new 2D table view that the columns shown don't have the same titles as found in either the table view or in the data window shown in the Table View. Are the columns under the x-y button in the 2D view updated to reflect the changes that one makes to the Column alias?
Also, is it possible to maintain the same order of columns no matter where a list of columns is displayed? I know I can order columns in the table view, but the table order is different in the data window and also in other places where one needs to display a list of the columns. As the number of columns increases it gets harder to find a particular column, especially when the order differs depending upon where you're looking.
Thanks,
Ed
Ed Fritzen
|
|
|
Re: Choosing X-Y Axes in 2D Views [message #1343 is a reply to message #1340] |
Sat, 17 July 2021 16:08 ![Go to previous message Go to previous message](/forum/theme/myThemeWithHFCSS/images/up.png) ![Go to next message Go to next message](/forum/theme/myThemeWithHFCSS/images/down.png) |
thomas
Messages: 694 Registered: June 2014
|
Senior Member |
|
|
If a column has an alias defined then DataWarrior should always display the alias instead of the original name. However, and usually invisible to the user, DataWarrior uses original column names internally to reference a column, e.g. when writing a template file and associating a filter with a column. Thus, if the GUI presents the original name if an alias exists, you found a bug. I checked the xy menu and some other places, but could not reproduce the effect. Do you have a small dummy file, which you could send me, that shows the effect?
It is true that column lists are not consistent regarding their ordering. Often they are in table order, but sometimes they are alphabetically. The xy menu separates two blocks in addition: Columns, which if selected would hide some of the data point because of empty values, are shown in red and are listed at the end of the list. A possible solution would be to have a preference setting regarding native or alphabetical order...
|
|
|
Re: Choosing X-Y Axes in 2D Views [message #1356 is a reply to message #1340] |
Fri, 23 July 2021 16:49 ![Go to previous message Go to previous message](/forum/theme/myThemeWithHFCSS/images/up.png) ![Go to next message Go to next message](/forum/theme/myThemeWithHFCSS/images/down.png) |
ELFritzen
Messages: 47 Registered: November 2019 Location: North Carolina, US
|
Member |
|
|
Hi Thomas,
Thank you for your reply. I've attached a dummy Datawarrior file that shows the problem I see. For the columns shown, the Column header does not have the same name when dropping down the x-y menu in a 2D view. For example, "Dundee Ave IC50" shows up as "mean of Dundee Ave IC50" in the x-y drop down menu. The same is seen for the other columns. These are only a few of the examples. There are others. It might be I set up these columns differently when I first added them, or someone else set them up. I hope this shows you what I see.
Thanks for your help.
Ed Fritzen
Ed Fritzen
|
|
|
|
|