Re: 2D view [message #15 is a reply to message #13] |
Sun, 26 October 2014 00:46 ![Go to previous message Go to previous message](/forum/theme/myThemeWithHFCSS/images/up.png) |
thomas
Messages: 693 Registered: June 2014
|
Senior Member |
|
|
There is a similar answer to both of the questions. There is not view specific way to toggle to
logarithmic axes nor to min/max definition for a particular view. However, one may define for any
column in the table view, that the nature of this column's data is logarithmic. Then all view axes,
marker colors and sizes, and all slider filters will act accordingly. Analogously, new min and max
values can be set for any table data column, which will then be used on view axes and filters.
You can change the these settings from the 'Data' menu with 'Set Value Range...' or 'Treat logarithmically...'.
There is one restriction: ranges can only be enlarged, because reducing would hide values and
logarithmic treatment can only be defined if all values are larger than zero.
Thomas
|
|
|