openmolecules.org Forum: Functionality » Tagging Data to a Particular Assay

Home » DataWarrior » Functionality » Tagging Data to a Particular Assay

Show: Today's Messages :: Polls :: Message Navigator

Re: Tagging Data to a Particular Assay [message #1031 is a reply to message #1030]

Fri, 07 August 2020 09:49

thomas
Messages: 747
Registered: June 2014

Senior Member

The proper alternative would be having the solubility data all in one column and a second column containing the source. If a row contains multiple measurements from different (or same) sources, then both columns should contains the same number of entries separated by '; ' or in separate lines. In dwar files line breaks are encoded as '<NL>'. You may tell DataWarrior that both columns are logically connected and the order of cell entries in both columns match. For that both columns must have the same group name defined in the column properties section. If your column titles would be 'Solubility Value' and 'Solubility Source' and the group name would be 'solubility' then the column properties section should look like this:
(Note: the white space in the column properties line must be a TAB)

<column properties>
<columnName="Solubility Value">
<columnProperty="groupName solubility">
<columnName="Solubility Source">
<columnProperty="groupName solubility">
...
</column properties>

Report message to a moderator

[Message index]

		Tagging Data to a Particular Assay By: ELFritzen on Thu, 06 August 2020 20:06
		Re: Tagging Data to a Particular Assay By: thomas on Fri, 07 August 2020 09:49
		Re: Tagging Data to a Particular Assay By: ELFritzen on Fri, 07 August 2020 13:59
		Re: Tagging Data to a Particular Assay By: thomas on Fri, 07 August 2020 17:46

Previous Topic:	.dwar file is not recognized
Next Topic:	Averaging Values in three columns

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Jun 13 04:45:57 CEST 2026

Total time taken to generate the page: 0.00696 seconds