openmolecules.org Forum: Cheminformatics » Automatic Calculation of Properties

Home » DataWarrior » Cheminformatics » Automatic Calculation of Properties

Show: Today's Messages :: Polls :: Message Navigator

Automatic Calculation of Properties [message #760]

Wed, 22 January 2020 20:20

ELFritzen
Messages: 47
Registered: November 2019
Location: North Carolina, US

Member

I was wondering if Datawarrior could automatically calculate molecular properties for new compounds appended to a Datawarrior file from an SD file? I have a Datawarrior File containing a number of calculated properties. As I append new compounds, the columns for these calculated properties are not populated. If I calculate properties after the compounds are appended, Datawarrior creates a whole new set of columns for the calculated properties. The only way I can think of to avoid all the additional columns is to open an SD file in Datawarrior, calculate the molecular properties and then append the new Datawarrior File to my master Datawarrior file. I was just wondering if there was a simpler way.
Thanks.

Ed Fritzen

Ed Fritzen

Report message to a moderator

Re: Automatic Calculation of Properties [message #769 is a reply to message #760]

Mon, 10 February 2020 22:15

thomas
Messages: 715
Registered: June 2014

Senior Member

This seems to be a frequent question. The problem of such an automatic property completion (and for consistency reasons calculated value completion) is that calculated values depend on other columns values. If there a multiple columns with calculated values, the order of calculation becomes important. This would be rather complex to track, especially since users may delete or change columns in between.

There is another solution that seems much simpler to me: You may create a macro that removes the calculated/property columns first and then freshly calculates them again. To do so:
- open file with the property columns
- start recording a new macro
- delete all property columns
- calculate all desired properties
- stop macro recording
- save the file. It now contains the macro, which can be started any time from the Macro menu.

Thomas

Report message to a moderator

Re: Automatic Calculation of Properties [message #774 is a reply to message #769]

Tue, 11 February 2020 22:42

ELFritzen
Messages: 47
Registered: November 2019
Location: North Carolina, US

Member

Thank you for the reply, Thomas. I'll give the macro a try.

Ed

Ed Fritzen

Report message to a moderator

Previous Topic:	Molecular Flexibility Descriptor
Next Topic:	Retrieve Wikipedia Molecules

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 22 18:39:08 CET 2024

Total time taken to generate the page: 0.05642 seconds