openmolecules.org Forum: Functionality » Opening SDF file with Datawarrior from command line

Home » DataWarrior » Functionality » Opening SDF file with Datawarrior from command line

Show: Today's Messages :: Polls :: Message Navigator

Re: Opening SDF file with Datawarrior from command line [message #414 is a reply to message #411]

Wed, 31 October 2018 00:32

abc123
Messages: 7
Registered: October 2018

Junior Member

I use a mac, is there some way to simplify this long command.

Even if we could have the File->Open dialog show the folder where DataWarrior was launched from, that would work too.

Report message to a moderator

[Message index]

		Opening SDF file with Datawarrior from command line By: abc123 on Tue, 30 October 2018 17:26
		Re: Opening SDF file with Datawarrior from command line By: thomas on Tue, 30 October 2018 22:23
		Re: Opening SDF file with Datawarrior from command line By: abc123 on Wed, 31 October 2018 00:32
		Re: Opening SDF file with Datawarrior from command line By: thomas on Sun, 04 November 2018 00:33
		Re: Opening SDF file with Datawarrior from command line By: nbehrnd on Thu, 20 June 2019 12:46

Previous Topic:	Datawarrior Protonates the Oxygen in a Phosphorous Oxygen Double Bond.
Next Topic:	network file export (cytoscape)

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Jun 19 22:31:51 CEST 2025

Total time taken to generate the page: 0.05840 seconds