Graphs [message #1189] |
Thu, 14 January 2021 07:12 ![Go to next message Go to next message](/forum/theme/myThemeWithHFCSS/images/down.png) |
sbembenek18
Messages: 59 Registered: April 2019
|
Member |
|
|
Once I close the 2D or 3D graphs -- how do I get them back again?
|
|
|
|
|
Re: Graphs [message #1427 is a reply to message #1424] |
Sat, 16 October 2021 17:51 ![Go to previous message Go to previous message](/forum/theme/myThemeWithHFCSS/images/up.png) |
thomas
Messages: 693 Registered: June 2014
|
Senior Member |
|
|
If you close a view, you cannot get it back with one click. You have to create a new one and to configure it to your wishes. Lets assume that you have closed all views except the table view. The next step depends on you DataWarrior version. Locate the header of the table view where it says 'Table View'. If one of the buttons on the right side of the header looks like a '+' sign, then click this button and select 'New 2D-View' from appearing menu. If there is no '+' button, then press the right mouse button after moving the mouse pointer over the 'Table View' area. A menu appears that lets you create a new 2D-view.
If you found a '+' button, then your views will also have a 'wrench'-button, which lets you configure the view. If there was no '+' button, then you need to move you mouse into the view itself and press the right mouse button to access the view configuration menu.
The last thing was less obvious and, therefore, newer DataWarrior version use '+' and 'wrench' buttons on the view title bar.
I hope I was more clear now.
|
|
|